6 wt for steelhead

wanative

Active Member
#1
I have a couple 6 wt. rods I'd like to try for steelhead this summer. Would they be adequate to handle 6 to 10 lb.fish? I do have a 8 wt. with a versi-tip line but I would prefer the lighter rod if feasible.
I don't think the flies I use would cause a weight issue as far as casting the 6 wt.
Thanks in advance for your input

Fred
 

Flyborg

Active Member
#2
Yes. Just don't be afraid to put the power on the fish when you hook the big ones. It may feel like a lot, but it's pretty tough to break a good rod fighting a fish at a good angle.
 
#3
I do have a 8 wt. with a versi-tip line but I would prefer the lighter rod if feasible.
Why?

An 8wt is a much better tool for the job. Being undergunned is infinitely less fun than having a bit of reserve power. And you're putting a wild fish in danger by going light and prolonging the fight. Not to say a 6 isn't enough.. I wouldn't use one on steelhead myself... But learn how they fight before going down in size.
 

Andy D

Active Member
#4
I also have both six and Eight weights that I use for steelhead. I would use the eight weight early in the summer season when casting larger flies and sink tips, and then use the six weight latter in the summer and fall for small flies over low water conditions. Also I would not use the six weight if the system your fishing on has fish that average over six to eight pounds.
 
#5
I use a 6wt for small water where the fish can't run very far AND where the odds of encountering a wild fish are nearly zero. If a river is big enough that the fish have room to run, or there's a decent chance of hooking wild fish, I'd take my 8wt.
 

GAT

Dumbfounded
#6
I use a 6wt for small water where the fish can't run very far AND where the odds of encountering a wild fish are nearly zero. If a river is big enough that the fish have room to run, or there's a decent chance of hooking wild fish, I'd take my 8wt.
Same here. Plus, on the smaller coastal rivers there's always a chance of catching a SRC and an 8wt for one of those guys is over-gunning.

(When Sage first opened their doors, I bought their first model rod in a 6 weight and used it for just about everything... including steelhead. The rod had no trouble handling the fish. Of course the original model Sage rod is much different than what they sell these days.)
 
#7
Why?

An 8wt is a much better tool for the job. Being undergunned is infinitely less fun than having a bit of reserve power. And you're putting a wild fish in danger by going light and prolonging the fight. Not to say a 6 isn't enough.. I wouldn't use one on steelhead myself... But learn how they fight before going down in size.
I agree, the 6 will work. But why? I would go with the 8.
 

David Dalan

69°19'15.35" N 18°44'22.74" E
#8
Maybe yes, maybe no.

If in doubt, go up..I say!

An old yarn says match the water not the fish. Certainly not always true (what is?), but explains why in some skinny water I do pull out the 4wt for steelhead. I'm talking creeks, and 24" is the general upper limit.
 
#10
Maybe yes, maybe no.

If in doubt, go up..I say!

An old yarn says match the water not the fish. Certainly not always true (what is?), but explains why in some skinny water I do pull out the 4wt for steelhead. I'm talking creeks, and 24" is the general upper limit.
Good point David, the water can definetly matter. Quite different catching a steelhead in a creek vs a large river with strong current. I have had smaller salmon in strong running water feel much bigger than they do in a small creek/stream.
 

David Dalan

69°19'15.35" N 18°44'22.74" E
#11
I use a 6 weight two hander for summers. I believe a 6 is enough rod for summer steelhead in the hands of a fisherman that has experience landing large fish. A heavier rod might be a better choice for someone that hasn't had a lot of experience catching steelhead.
You make a good point here...I'm talking single handers. If the question is regarding 2 handers, then a 6wt would be fine, my goto is a 7wt (fast) two hander.

Rule of thumb is 3 weights...I.e. 6wt 2 hander is = 9wt single, I thought.
 
#12
I use a 6 weight two hander for summers. I believe a 6 is enough rod for summer steelhead in the hands of a fisherman that has experience landing large fish. A heavier rod might be a better choice for someone that hasn't had a lot of experience catching steelhead.
I catch steelhead on a 5wt two hander. But that rod has about as much power to fight fish as an 8wt single hander.
 

KerryS

Ignored Member
#15
You make a good point here...I'm talking single handers. If the question is regarding 2 handers, then a 6wt would be fine, my goto is a 7wt (fast) two hander.

Rule of thumb is 3 weights...I.e. 6wt 2 hander is = 9wt single, I thought.
I will agree that a 6 two hander is likely more capable than a 6 single but only because of its length. There is no way my 6 two hander is equal to a 9 single. In fact it can't even be compared to my 8 single.