WTB WTB: project glass trout rod

Discussion in 'Classifieds' started by Ben Guss, Nov 3, 2012.

Thread Status:
Not open for further replies.
  1. Ben Guss

    Ben Guss Member

    Joined:
    May 13, 2009
    Messages:
    423
    Likes Received:
    2
    Location:
    Olympia, WA
    Hi all,
    I'm looking for an old glass trout rod. Something equivalent to a 4wt. I'm looking to make it into a small stream switch rod. let me know what you have and what you'd let it go for.
    Many thanks,
    Ben
     
  2. Ben Guss

    Ben Guss Member

    Joined:
    May 13, 2009
    Messages:
    423
    Likes Received:
    2
    Location:
    Olympia, WA
    Some one must have an old glass rod close to this laying around...
     
  3. tonemike

    tonemike fish'n glass

    Joined:
    Dec 28, 2003
    Messages:
    435
    Likes Received:
    39
    Location:
    Monroe, WA.
    it's tough to find an old glass 4wt. most old glass seem to be 6 to 8wt rods. there are some great modern rod builders/manufacturers that sell 4wt rods, but you may end up waiting forever to find an "old" one here.

    you may check in at fiberglassflyrodders.com to see if any of my fellow glass enthusiasts have anything that may work for you.
     
  4. S Fontinalis

    S Fontinalis Active Member

    Joined:
    Jul 25, 2011
    Messages:
    463
    Media:
    32
    Likes Received:
    180
  5. Jeff Dodd

    Jeff Dodd Active Member

    Joined:
    Dec 4, 2004
    Messages:
    1,701
    Media:
    1
    Likes Received:
    457
    Location:
    Langley, WA
    Ben
    I have 2 old fenwick rods I picked up a few years ago. Both are fly rod blanks used for ultra light spinning rods. Metal ferruls however and short at 7 feet I think. Very light rods. I am keeping to strip and rebuild someday but I don't need 2 of them
    You can have 1 if this is what you are looking for, but I suspect it is not....

    Good luck in your search
    Jeff
     
  6. Jeff Dodd

    Jeff Dodd Active Member

    Joined:
    Dec 4, 2004
    Messages:
    1,701
    Media:
    1
    Likes Received:
    457
    Location:
    Langley, WA
    Ben. PM left for you.
    The blank is: FL 84-5, light brown color. I don't know if it is a 4wt, but it is very soft. My thought is FL is fly line. ?

    I have not built a rod, but it is possible this rod used metal ferruls on a rod that does not need them. The tip section is longer than the bottom. Also, it is cork with 2 rings for the reel foot. Not the usual spinning reel set-up.

    Jeff
     
  7. tonemike

    tonemike fish'n glass

    Joined:
    Dec 28, 2003
    Messages:
    435
    Likes Received:
    39
    Location:
    Monroe, WA.
    just checked the Johnson Fiberglass book, and jeff's FL84-5 is the lightest blank they made back in the day. rated a 5wt and supposedly only 1 1/4 ounces. length is 7 feet. you will be hard pressed to find anything lighter that this 5wt... and like lots of decent fiberglass, it may like 4-6wt lines depending on your taste and the line characteristic.
     
  8. Jeff Dodd

    Jeff Dodd Active Member

    Joined:
    Dec 4, 2004
    Messages:
    1,701
    Media:
    1
    Likes Received:
    457
    Location:
    Langley, WA
    Thanks Tonemike. That is more information than Fenwick was able to provide me.

    First thing I noticed about these rods is they are very light in the hand.
     
    tonemike likes this.
  9. tonemike

    tonemike fish'n glass

    Joined:
    Dec 28, 2003
    Messages:
    435
    Likes Received:
    39
    Location:
    Monroe, WA.
    johnson and son gathered tons of data from old catalogs (and very knowledgeable old guys) to make a great book called "fiberglass fly rods." some call it the fiberglass bible. most info on nearly every fiberglass fly rod made back then. not bound terribly well, but a WEALTH a knowledge
     
  10. Nooksack Mac

    Nooksack Mac Active Member

    Joined:
    Dec 19, 2002
    Messages:
    2,004
    Likes Received:
    134
    Location:
    Bellingham, WA, USA.
    Ben, I have a little six foot Herter fiberglass rod that I haven't used much, because it's a five-weight (according to its maker), and that line seems a few sizes larger than a rod of that size should be designed for. But recently, out of curiosity, I tried it with a 4-weight line, then a 3-weight, then finally a 2-weight. All of them genuinely flex the rod! None of them feel too light. And I've only had it for 44 years!

    The point is that rods don't know their pedigree. They're just flexible levers, and their parameters are whatever they are. Try your four-weight line on different glass rods. You may be pleasantly surprised.
     
  11. Jeff Dodd

    Jeff Dodd Active Member

    Joined:
    Dec 4, 2004
    Messages:
    1,701
    Media:
    1
    Likes Received:
    457
    Location:
    Langley, WA
    Tonemike
    Interesting information about your the Johnson.Fiberglass book.

    Is this the title, and will it be hard for to find a copy available for sale?

    While looking in the garage I found I have a few other fiberglass rods that I had half-way forgotten about. A reference book would be useful tool. Like my old outboard motor reference book, handy to have about once/year.
    Thanks
     
  12. NewTyer1

    NewTyer1 Banned or Parked

    Joined:
    Jan 9, 2011
    Messages:
    560
    Likes Received:
    28
    Location:
    Shenandoah Valley, Virginia
    I have what I think is a 7'6" Heddon "Pal" it has a little color loss on the blank but, I believe it is still fishable. Spring for shipping and an extra 10 bucks and you can have it
     
  13. para_adams

    para_adams Active Member

    Joined:
    Aug 29, 2004
    Messages:
    274
    Likes Received:
    97
    Location:
    Bothell, WA
    I have a 7-1/2 foot Lamiglas "S Glass" 5 weight. Haven't fished it in about 2 decades. $20?
     
  14. Ben Guss

    Ben Guss Member

    Joined:
    May 13, 2009
    Messages:
    423
    Likes Received:
    2
    Location:
    Olympia, WA
    Thank you all for the generosity, I sent some PM's and hopefully will find something that fits the bill!
     
  15. tonemike

    tonemike fish'n glass

    Joined:
    Dec 28, 2003
    Messages:
    435
    Likes Received:
    39
    Location:
    Monroe, WA.
    the authors are Johnson & Johnson and the title is Fiberglass Fly Rods. i think i picked mine up for around 16 bucks . there's no better resource book for fiberglass fly rods. i just saw it on amazon for 30 bucks, not sure if you can find it cheaper elsewhere.
     
  16. Ben Guss

    Ben Guss Member

    Joined:
    May 13, 2009
    Messages:
    423
    Likes Received:
    2
    Location:
    Olympia, WA
    Thanks for the info and offers!
    I'm still looking for a little bit of a longer (8.5' or longer) 4-6 wt glass rod.
    Any one have one?
    Many thanks!
     
Thread Status:
Not open for further replies.

Share This Page