Kind of Rogue-like; changed the front end around a bit. hook - Dai Riki 280 #6 thread - UTC 140 tan body - 2mm foam tan underside - Furry Foam (adhesive backed) yellow binder strip - 2mm x 2mm foam wing - deer hair mid-wing - Congo Hair tan legs - medium rubber brown indicator - foam orange insert needle in vise, then foam on the needle; start thread fold foam forward; 2 soft loops (so the foam isn't cut), pull tight and create first segment lay furry foam strip on one side and tie in pull foam back, wrap thread forward, then create next segment; repeat, tie off, trim thread, trim tag end of Furry Foam (not shown) slide body off needle, poke a hole in it and slide on (debarbed) hook start thread, wrap back to hook point; attach binder strip and tie down brush a little Super Glue on binder strip, squeeze body segment trim Furry Foam and top layer of body at eye poke hole at hook eye, pull foam up and let eye poke thru; tie off move thread back with crossing wraps over the back; clean, stack, measure (even with butt) a clump of deer hair, cut to length and tie in tie in rear legs tie in CH and trim butts move thread back to eye, fold foam forward over eye, tie down tie in front legs move thread back one segment, tie down foam, tie in indicator; tie off, SHHAN trim everything to length semi-ventral Regards, Scott