Fishfinders...who uses them?

Discussion in 'Stillwater' started by JMitchell, Mar 31, 2010.

  1. JMitchell

    JMitchell Active Member

    Joined:
    Jul 19, 2009
    Messages:
    188
    Likes Received:
    38
    Location:
    Selah, wa
    I have been thinking about getting the Hummingbird 140 for my toon, but figured I would throw the question out. Who uses these? Are you using them mostly for depth/contour or actually to locate fish as well? Is the side finder option worth it? The few guys I have talked to seem to mostly use these to fish chiros deep for finding exact depth and stick it 6-12 inches off the bottom. Any ideas/thoughts are greatly appreciated.

    Jarron
     
  2. Plecoptera

    Plecoptera Active Member

    Joined:
    Jun 11, 2008
    Messages:
    654
    Likes Received:
    52
    Location:
    Port Townsend
    I mainly use mine on new lakes that don't have a topo map, so I can have an idea of the bottom structure & depth. Sometimes I have used it to locate fish, but aside from a few occasions I have never noticed it getting me onto more fish. It does mark suspended objects, but whether these are fish or not is questionable. Some of the better finders are pretty accurate and are better at distinguishing fish.

    For getting chironomids on the bottom, the best method is to use a pair of hemostats. I've found depth readings from most fish finders are off by as much as 5', so if your looking to be 6-12" from the bottom I wouldn't put much faith in one.
     
  3. Lakebuzzer

    Lakebuzzer I like to rip lips,,

    Joined:
    Apr 13, 2009
    Messages:
    83
    Likes Received:
    0
    Location:
    Where ever the fishing is at it's best
    I use a humminbird 140C fishing buddy. I use it to locate shoals, drop offs , depth, surface temp, thermocline and structure. I will not go on a lake without this tool on my boat.
    As far as plecoptera stating that depth finders are not accurate hasn't really ever used a quality depth finder or knows how to properly adjust one. I use mind to determine if the bottom is mud, rock or weeds, what the tops of the weeds are to make sure my fly is above the weeds not in the weeds snagging up. I set my buzzers and my bung by the depth and its so much quicker to set up then using a hemostat or the tip of my fly rod.
    Buy one, you wont regret it.

    Kevin
     
  4. Jerry Metcalf

    Jerry Metcalf FishyJere

    Joined:
    Sep 29, 2005
    Messages:
    446
    Likes Received:
    93
    Location:
    Enumclaw, WA
    I found that in a pontoon, the hummingbird type finders are a real pain. They are awkward, hard to place and get in the way. On a pram, they are great. For my pontoon, I bought a handheld depth finder about the size of a flashlight. I get good depths but no fish indications. It stores in a pocket and the batteries last a summer. It is a Vexilar LPS1.

    Jerry
     
  5. Nick Clayton

    Nick Clayton Active Member

    Joined:
    Jun 13, 2006
    Messages:
    6,053
    Likes Received:
    7,553
    Hand held depth finder; what does on of those babies go for?

    Nick
     
  6. Trout Master

    Trout Master Active Member

    Joined:
    Feb 26, 2003
    Messages:
    1,403
    Likes Received:
    1
    Location:
    Twisp
    I have used eagle and now have a hummingbird. I dont see what Jerry is saying about being a pain in the ass, set up with quick brackets for transducer and unit display and have a small 12v motorcylce battery to power it. I use it for depth /contours etc. Works great.
     
  7. IveofIone

    IveofIone Active Member

    Joined:
    Sep 23, 2003
    Messages:
    4,112
    Likes Received:
    3,292
    Location:
    .
    I wouldn't be without one but I use it only to determine depth. Finding fish or side finding has been of very little use to me over the years. But for determining if you are in 23' of water and should be using a Type VI line or 8' of water and should have on an intermediate they just can't be beat.

    Shown are 3 different ways I have mounted them. The Fishin' Buddy on the 'toon is a new one, an entry level model that is very lightweight. I have it mounted on the footrest with an adjustable clutch for raising and lowering it. Very handy and very visible and not at all in the way.

    Previously I had my Eagle finder mounted on the South Fork in the manner shown and again it was completely out of the way but very handy and quite visible. The box contains a small gel cell battery that seems to last indefinitely.

    Now I have tucked the Eagle into the rear corner of my pram where it is a perfect fit and the cabling runs down the transom to the transducer.

    If you fish the same lake or lakes over and over a finder may not be so important once you learn the water. But if you fish all over hell's half acre like I do they sure can save a lot of time getting dialed in.

    Ive
     
  8. Bob Jones

    Bob Jones Still truckless now farther away

    Joined:
    Feb 23, 2009
    Messages:
    1,693
    Likes Received:
    2
    Location:
    Last seen in Portland Or. via Tacoma,Puyallup, Wa.
    I like it Ive. I've never used one but that would be the way that you are doing. I probably won't ever do it now, too late in the game. but good thinkiing.
     
  9. ral

    ral Rich Layendecker

    Joined:
    Sep 9, 2002
    Messages:
    199
    Likes Received:
    0
    Location:
    .Redmond WA
    Ive:

    I just got a Fishing Buddy and like the way you mounted it to your toon. Thanks for the idea.
     
  10. Blue

    Blue Active Member

    Joined:
    Nov 15, 2006
    Messages:
    1,262
    Likes Received:
    130
    Location:
    Salt Lake City, UT
    Home Page:
    First off, HUMMINBIRD is the best I have ever used. I have been using one for years. Mounted it to four different Pontoons and 2 float tubes. Piece of cake.
    Newest boat, however, Ram Mounts and Aluminum tube for Transducer. Works on my X5 and my H3.
    Definitely makes deep nymphing much easier. great for finding fish too, but the sad thing is, you can be looking at tons of fish on the sonar but can't BUY a bite LOL
    My hubby had the old Fishing buddy and it was total crap, but Humminbird is building the new ones and the cone on them is awesome!
    I like my 300 though old, totally reliable.
    Power, I use the small rechargeables. They are great and last a long time. Can't spill. Plus you can get really small 12V at Security Systems stores.

    [​IMG]

    [​IMG]

    [​IMG]
     
  11. barbless

    barbless Member

    Joined:
    Dec 29, 2003
    Messages:
    313
    Likes Received:
    1
    Location:
    Seattle, WA, USA.
  12. Trout Master

    Trout Master Active Member

    Joined:
    Feb 26, 2003
    Messages:
    1,403
    Likes Received:
    1
    Location:
    Twisp
    Ram mounts are the ticket, can be a little pricey but very functional
     
  13. Jerry Metcalf

    Jerry Metcalf FishyJere

    Joined:
    Sep 29, 2005
    Messages:
    446
    Likes Received:
    93
    Location:
    Enumclaw, WA
    I have something similar, in price and size, to what Barbless gave us the link to. Nothing hanging off the boat, nothing.

    Jerry
     
  14. FLYRODR

    FLYRODR Guest

    Get one... you'll use it alot. I use the Fishing Buddy and I always have other guys asking for the water depth. Plus they're great for locating structure.
     
  15. JMitchell

    JMitchell Active Member

    Joined:
    Jul 19, 2009
    Messages:
    188
    Likes Received:
    38
    Location:
    Selah, wa
    Some really good ideas and pictures of mounted hardware. I have usually used the hemo trick or just dropped anchor to figure out depth. Obviously I am missing out on the structure/contour and possible fish marking.

    I think what Ive said is a good point, if you fish a lot of the same lakes over and over, not so important. I am starting to expand my horizons and fish all different lakes, so I think this would be a healthy investment.

    Does the fishing buddy come with the mounting hardware, or is that a seperate purchase? I like the look of mounting off the left footrest. What is the life of the batteries like on the lightweight models? Thanks again for the pointers/opinions.

    Jarron