Tom Moore's embellishment of Gary LaFontaine's Buzzball, adding wing & shuck from a Sparkledun. I'll leave up to others to decide whether it's an improvement or just gilding the lily.
hook - Dai Riki 305 #16
thread - MFC 6/0 hot orange
shuck - Congo Hair amber
hackle - orange, dun, grizzly
wing - deer hair
mash barb, start thread at 2/3 mark
clean, stack, measure (shank length) a clump of deer hair
tie in with tips forward; trim butts, set upright with thread wraps in front
tie in CH; fold, wrap to bend, trim (gap width past bend)
tie in grizzly hackle (sized to hook)
tie in orange and dun (use the cheapest stuff you can find since most is going to end up on ther cutting room floor)
wrap orange and dun to eye; tie off
trim a bit less than gap width top/bottom and gap width on the sides
wrap grizzly; tie off, half hitch x 2, SHHAN
trim grizzly even with the orange/dun on the op and bottom, leave the sides as-is
Regards,
Scott