NFO valve problem

Discussion in 'Watercraft' started by Driftaway, May 21, 2012.

  1. Driftaway

    Driftaway New Member

    Joined:
    Aug 4, 2011
    Messages:
    29
    Likes Received:
    2
    Location:
    Scranton Pa
    I have a problem with valve on a renegade sticking. first is was stuck closed and had to keep your finger on it to dump the air, now it is stuck open and we have to float hopeing the valve cover would hold the air in. I have tried emailing and calling and get no response. I found the thread on here about trying to get valve replacements but he never said if he got his problem fixed. any ideas?
     
  2. shawn k

    shawn k Member

    Joined:
    May 24, 2005
    Messages:
    697
    Likes Received:
    18
    Location:
    buckets worldwide
    try to find out where the valve is leaking. fully inflate the boat with the valve closed spray some soapy water in and on the valve if bubbles form on the outside of the valve it is either cracked or the seal is bad. If it bubbles up on the inside clean it with a q-tip dipped in rubbing alcohol and then spray some silicone lubricant in the valve and open and close it a few times. Most likely it is a piece of sand or grit stuck in the valve.
     
  3. Ed Call

    Ed Call Mumbling Moderator Staff Member

    Joined:
    Jun 9, 2008
    Messages:
    17,947
    Likes Received:
    2,253
    Location:
    Kitsap Peninsula
    I took one of my valves out. It was sticking, similar to yours. I washed it out, figuring there was some grit. It then seemed to work fine. You could replace the valve with a different type. NRSweb.com carries some. Aire/Outcast does too.
     
  4. Rob Ast

    Rob Ast Active Member

    Joined:
    Apr 18, 2005
    Messages:
    2,057
    Likes Received:
    399
    Location:
    West Pugetopolis WA
    I had a leak and took the valve out. There is a little dome that helps with the click open/click closed feature and this had broken off. I did get a replacement valve from Dave and it was easy to replace. Ed, I'm not sure you can replace the valve with a different one because it is my understanding the valve body is a different diameter than the more standard valves. You can't replace the internal portion.
     
  5. Driftaway

    Driftaway New Member

    Joined:
    Aug 4, 2011
    Messages:
    29
    Likes Received:
    2
    Location:
    Scranton Pa
    Thanks guys, I will try washing it out. To be clear it is not leaking. It is stuck open and we cannot close it. we have to pump it up like mad and quickly put the cover on it. The boat has only been used a couple of times. I would buy replacement valves if my emails or calls were returned
     
  6. Blue

    Blue Active Member

    Joined:
    Nov 15, 2006
    Messages:
    1,251
    Likes Received:
    128
    Location:
    Salt Lake City, UT
    Home Page:

    I am surprised you own a NFO. I thought from all your other post you bought from Catchercraft "a sponsor on this site"
    The valves are NRS style Bravos. You want, I will try to get you one.
     
  7. Rob Ast

    Rob Ast Active Member

    Joined:
    Apr 18, 2005
    Messages:
    2,057
    Likes Received:
    399
    Location:
    West Pugetopolis WA
    Stuck open is the initial problem I had with the broken dome part. You. Should be able to take it out and fix it to the point where it will function until you can get a replacement.
     
  8. Driftaway

    Driftaway New Member

    Joined:
    Aug 4, 2011
    Messages:
    29
    Likes Received:
    2
    Location:
    Scranton Pa
    No I dont have a Catchercraft, But I feel its rude to try to take business away from a site sponser. They help pay for this site that some indirectly advertise on for free. Thanks for the offer of getting the valve.
     
    shawn k and jessejames like this.
  9. Driftaway

    Driftaway New Member

    Joined:
    Aug 4, 2011
    Messages:
    29
    Likes Received:
    2
    Location:
    Scranton Pa
    Where did you get the valve, NRS? I really should not have to buy one but I just want to get this fixed.
     
  10. Blue

    Blue Active Member

    Joined:
    Nov 15, 2006
    Messages:
    1,251
    Likes Received:
    128
    Location:
    Salt Lake City, UT
    Home Page:



    Sorry for the way I wrote that, it should have had a ? behind NRS. I don't know if they carry Bravos. They are Italian I think. I live about 30 minutes from NFO, plus I don't seem to have trouble getting a hold of any of the people at NFO. But, I would be happy to try to get a valve for you. The old what goes around, comes around.
     
  11. Rob Ast

    Rob Ast Active Member

    Joined:
    Apr 18, 2005
    Messages:
    2,057
    Likes Received:
    399
    Location:
    West Pugetopolis WA
    NRS does not carry the bravo valve, nor does anyone else I could find. I happened to e-mail NFO and got a quick reply and Dave sent me a valve free of charge.
     
  12. Driftaway

    Driftaway New Member

    Joined:
    Aug 4, 2011
    Messages:
    29
    Likes Received:
    2
    Location:
    Scranton Pa
    Thanks I'll try again
     
  13. Driftaway

    Driftaway New Member

    Joined:
    Aug 4, 2011
    Messages:
    29
    Likes Received:
    2
    Location:
    Scranton Pa
    well just as a follow up, Blue put me in touch with NFO. I was told that a small collar sometimes comes off inside the valve and I have to take off the valve by making a wrench with only two teeth and I have to find the collar in the tube and re-install it. No new valve for me lol
     
  14. Ed Call

    Ed Call Mumbling Moderator Staff Member

    Joined:
    Jun 9, 2008
    Messages:
    17,947
    Likes Received:
    2,253
    Location:
    Kitsap Peninsula
    Once done think of how successful a field repair tactician you will be!
     
  15. Blue

    Blue Active Member

    Joined:
    Nov 15, 2006
    Messages:
    1,251
    Likes Received:
    128
    Location:
    Salt Lake City, UT
    Home Page:
    Good to know, I had no idea. I need to make one of these valve tools. You got a picture of it?