i have 2 different reel seat setups, one for a #6 and the other came with a #5 rod building kit. even though it has beena while since i built a trout rod, i cannot seem to get my reel to stay snug in the seet. the seat is already epoxied onto the blank and the cork grip is positioned but not yet epoxied. when i place the reel into the seat at tighten it down, the locking screw runs out of threads before the reel is tight and i cannot figure out why. the first though was i was missing a piece, but i am sitting here also looking at the cabelas page and according to the picture of the one i bought i am not missing anything. am i doing something wrong? i have built several rods without any problems, but i am stump here.