Hey all, I briefly tried looking some of this up on the forum but I guess no one has posted something similar so far. I have to say that I am not trying to trash the Scadden boats as I really do like them and the versatility they provide, but instead am trying to see if someone else has had a similar issue with a frameless scadden model that could shed some light onto how they handled it. I recently bought an outlaw assault at the fly fishing show back in February, and have loved using it on the lakes in the spring. Unfortunately, as much as I like how its built for the most part I have been having some problems. I was fishing with it on a lake one afternoon when I noticed my seat kept getting fairly soft, and before I got done fishing for the day I ended up having to pump it up multiple times in 2 hours. When I got home, I looked around and sure enough found a hole in the back seam of the seat (shown in the pictures attached). It appears to be right in the middle back portion of the seat, and there is a small little pre cut v-notch right where the hole was. The seams to me seem to be just pancaked together so it sticks out like a tail and there is about 1.5 inches of material glued together. After feeling around, it looks like the glue didn't hold too well in the middle of the seam and it started pulling apart right at the middle, where it eventually travelled and created the hole you see. I like the boat and the versatility, but so far I've also had 1 other clean hole in the side as well from only being on a lake for short periods of time (most likely my fault, I pumped it up for the 3rd time and found a pin hole on one of the tubes and ended up patching it with knot sense briefly before later fixing it with aqua seal). I did contact NFO about the seat hole and what I got back was that I could either try fixing it with aqua seal or I could send it in to them as they could better assess the problem in person and then fix it. I was hoping to not have to pay the shipping to send it back to Dave to get it fixed, but if its a seam problem I know it would be better off getting sent back to get fixed. I guess I'm just trying to hear about other peoples experiences before finally caving and doing it.