Pontoon Rod Holder

 


  1. prev
    Pontoon Rod Holder
    next


    Pontoon Rod Holder



    This is what mine was supposed to look like. If I had a better way to make sure I cut the pipe straight it would be this nice.
    ~This photo was stolen off the internet~



    <<
    IMG_6508.JPG IMG_6586.JPG rodholder.jpg DSC00956.JPG Livy.jpg
    >>
    1. Jason

      Trout Bum
      See all User Photos

      Registered: April 2003
      Location: Edmonds, WA
      Posts: 666
      • Pin It
      ssssssssss
      Linked Thumb: 
      Linked Image: 
      Date: 3-2-06
      Views: 3,214
  1. Comments

    sixfinger

    Ryan Haseman
    you could set up a jig pretty easy. take a 2x4 and bore a hole in the middle to the OD of the pipe then take a sawsall and cut perpendicualr to the 2x4 about 1/2 way and going through the center of the hole. Then stick it in a vice and feed the pipe in from the bottom and control the sawsall with the other hand.


    If you dont own a sawsall or are inexperienced in operating one (with one hand especially) you could do the same with a hack-saw, it would just take longer.
    #1 3-2-06 11:03pm

    Jason

    Trout Bum
    I had it in a vise and used a jig saw. What I will do once I get the room is get a table saw and put the fence at half the pipe diameter. And to protect the rod better it will be felt lined.
    #2 3-3-06 3:42pm

    KermodeDon

    Spirit Bears
    I like it! I am going to have to try and make one.
    #3 5-1-06 9:50pm


Photo Sharing Gallery by PhotoPost
Copyright © 2014 All Enthusiast, Inc.