Cutter inverted midge by Riseform

 


  1. Cutter inverted midge by Riseform

    View Larger Image


    Cutter inverted midge by Riseform



    Tail: black foam, Body: thread wrapped with fine wire or Krystal flash, Thorax: super fine dubbing, white foam pulled over like a wing case, Hackle: Grizzly, trimmed on bottom



    1. riseform

      See all User Photos

      Registered: February 2007
      Location: Tacoma, WA
      Posts: 1,104
      • Pin It
      ssssssssss
      Linked Thumb: 
      Linked Medium: 
      Medium Image: 
      Date: 6-29-08
      Views: 1,047
      Photo Tags: 1
  1. Comments

    Rob Zelk

    I swing, therefore i am.
    Those things look sweet! It seems like you may have trouble keeping a fish on with the material so far down the hook, but it works eh? I like the pics of these in the water.
    #1 6-30-08 3:44am

    trouthog1
    What hook do you tie these on?
    #2 6-30-08 4:51am

    riseform
    Rob: We'll have to see. This was the only way I could duplicate the inverted look from the video. I'm a little worried about the foam preventing hookups (which folds just short of the hook point), but when I went with a shorter version, the tail would sink too easily. This fly sits reliably in the water as designed. As we test them we'll post feedback in the original swap thread (or gallery).


    Trouthog: It's a Tiemco 2488 emerger hook, sizes 14 and 16 for this swap.
    #3 7-1-08 3:30pm

    troutloop

    Pescando Con Mosca
    I really like what you have created here it is one of the best looking midge emergers I have seen keep up the good work.
    #4 6-14-09 4:10pm

    kelvin
    man those are PIMP
    I bet they hook up!
    #5 4-12-11 4:54am


Photo Sharing Gallery by PhotoPost
Copyright © 2014 All Enthusiast, Inc.