Fly Fishing Photo Gallery

  1. Search

    Recent Photos
    1 day  7 days  14 days

  1. Statistics
    Users 79,744
    Photos 44,265
    Comments 69,421
    Views 30,951,832

  1. Posting Calendar
    « July 2014
    SunMon TueWed ThuFri Sat

  1. Random - Gallery


    [ Member Galleries ]


    [ Member Galleries ]


    [ Member Galleries ]

    · more ·

  1. Home > Main > Swaps > 2004 > 2004 Marathon Fly Swap -Terrestrial > Slide Show



    Transpar-Ant tied by Bob Ellis


    1. Ron Eagle Elk

      See all User Photos

      Registered: September 2003
      Location: Yelm, WA, USA.
      Posts: 1,741
      • Pin It
      Linked Thumb: 
      Linked Image: 
      Date: 3-4-05
      Views: 1,334

  1. jessejames

    Good looking fly is that hot glue for the thorax?
    #1 3-4-05 4:15pm

    Bob Ellis
    It's five-minute epoxy.
    Harrison Steeves pattern in "Terrestrials" by Harrison R. Steeves III
    and Ed Koch

    Hook: #16 to #20 straight eye, Tiemco 101

    Underbody: Monocord for larger hook sizes, 6/0 or 8/0 for the smaller
    sizes. Yellow, rust, cinnamon, or a combination of these, using
    different colors for abdomen and head.

    Body: Devcon five-minute epoxy

    Legs: Black or furnace hackle

    1. Build up a small underbody for both the thorax and the abdomen. Leave
    a portion of the hook shank bare between the two underbody portions.
    The abdomen should be somewhat larger than the thorax.

    2. Mix a small amount of five-minute epoxy, and with a dubbing needle,
    apply an appropriate amount to both the abdomen and thorax. As you apply
    the epoxy, the vise may be rotated and the body built up and tapered as
    desired. By rotating the vise slowly for a few minutes, a perfectly
    shaped and even body can be obtained. Continue rotating the vise until
    the body has partially hardened (it only takes a few minutes).

    3. Remove the completed body from the vise by grasping the eye of the
    hoook with a fine-pointed pair of forceps so as not to touch the still
    tacky body.

    4. Place the bend of the hook on a magnetic strip cemented to a block
    of wood so that the body will contact nothing until it is completely

    5. Allow the completed bodies to cure for a few hours. Tie in the
    appropriate size hackle between the abdomen and head, give it a few
    turns, and tie it off to form the legs. If you do not want to use
    hackle, three strands of moose body hair may be figure-eight wrapped
    between the thorax and abdomen and then trimmed to form the six legs.
    #2 3-17-05 5:25pm

Photo Sharing Gallery by PhotoPost
Copyright © 2012 All Enthusiast, Inc.