Washington Fly Fishing Forum banner
Status
Not open for further replies.
1 - 6 of 6 Posts

· Registered
Joined
·
1,313 Posts
Discussion Starter · #1 ·
2000 Custom Built 15.5' x 7' Piranha Sled
Roomiest, most functional sled you will ever find in this length.
Built uncommonly strong with .195 bottom and .125 sides.
Modified V entry into slightly rolled flat bottom to break chop and track well.
Super stable and drafts shallow due to wide beam.
Features include:
-marine vinyl over marine plywood floors
-super strong welded ladder rails with full length rod and gear trays
-new battery
-rocker switch fuse panel
-bilge pimp
-running lights
-front full width storage
-front full width fish locker (separate from storage)
-two front padded folding seats sitting on aluminum storage pedestal boxes
-Deluxe XL helmsman seat on moveable tripod
-3 anchors with multiple anchor ropes
-4 life jackets and throwable cushion
-Hummingbird TX300 fish finder
-Rod holders
-new 6 gal forward mounted fuel tank with in-line hard mounted cartridge style fuel/water separator
-transom to outboard motor support arm
-boat cover
-custom, easy on/off bimini top (2/3 coverage) with weather cover
Motor
New Mercury 4 stroke 40 hp with electric start, power tilt and trim.
Purchased from Stevens Marine 8/2009, 3 yr. transferrable warranty good thru 8/2012
Motor set up with power prop, jumps onto full plane very quickly, 30 mph at 2/3 throttle.
Approximately 40 hours on motor, which was precisely broken in per factory specifications.
Trailer
2000 custom galvanized Shoreline trailer with LED lights, like new tires, never used spare, side bunks, bearing buddies, new roller winch, new heavy duty tie down straps.

I used this boat for fly-fishing in upper tidewater, so it spent most of its time anchored, hence the low motor hours.
Looking for $10,000, which is about half of full package replacement value.
Registration paid thru 2011.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top