Washington Fly Fishing Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance. 

1 - 1 of 1 Posts

·
Premium Member
Joined
·
3,623 Posts
Discussion Starter · #1 ·


A bit different look than with the traditional flanking flank feathers. This one's a bit unruly; I'll chalk that up to a thicker quill stem on the mallard (or I just screwed this one up). Tried a few options for the body (marabou, wound saddle feather) but liked the rabbit best; weighted shank optional.

hook - Mustad 9671 #4
thread - Danville 6/0 black
body - cross-cut rabbit yellow
wing - mallard flank
hackle - hen grizzly

start thread, wrap back to the 1/3 mark; more a function of the length of the rabbit fur; I wanted the tips to end about a gap width past the bend (yrmv))



tie in zonker strip, brush shank with Super Glue; wrap to about the 3/4 mark, tie off/trim







prep mallard flank



tie in by tip, run scissors blade back along the top side to help the fibers lay down, wrap, tie off/trim





prep hen; tie in by tip, repeat the scissors thing (not shown)





wrap hackle, tie off/trim, whip finish, SHHAN







Regards,
Scott
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top