Washington Fly Fishing Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
114 Posts
Discussion Starter · #1 ·
Thanks to those whom were interested it this. Sorry it took so long to get them posted. (Thanks to Chris :THUMBSUP ) Anyway if anyone one need additional info, measurements, whatever, I still have some hand dwg's from the planning stage. Some are applicable, some aren't because of design changes on the fly. Pardon the pun, haha. If I were to do this again, I might I have something made that would plug in where the anchor assy mounts on the frame (stainless-steel). But this works great and wasn't that hard to make, a couple evenings. Here's the link to go, 8 pics in all.

http://www.washingtonflyfishing.com/jim/

Jim J.
 
G

·
Nice looking rig. But I don't think that it would work for me. As I would have to buy a table saw to cut the wood and then I would have to buy a pickup to carry it in. As you see the cost is way out of my range. Jim S. P/S just having fun. :WINK
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top