Washington Fly Fishing Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I am looking to make a couple of fly rod holders for my pontoon boat. Have some pvc pipe and a shop full of power tools. Any body have any designs they like? I like simple. It's usually the best method. Thanks.
 

·
Registered
Joined
·
57 Posts
I took some abs 1 1/2" cut lengthwise on a tablesaw twice to make a c out of it put two end caps on zip tie the tubes too the frame now when i push my toon too the lake on the wheel my rods have a safe place i have two 9'two piece rods i just cut the abs long enough too hold them broken down. If you want to use pvc use sc 40 a lot stronger
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top