Washington Fly Fishing Forum banner
Not open for further replies.
1 - 3 of 3 Posts

· Bent rods and tight lines!
109 Posts
Discussion Starter · #1 ·
I bought this a few years back from an Orvis guide who used it in his business so it is set up nice. Friends I used to fish with have moved on so I find myself using my pontoon more now. Better to have someone to use this than just set around.

This is ready to fish as all you need is included when leaving.


13+ ft. Osprey Momentum raft

Always covered and I have used 303 Aerospace Protectant to preserve the raft material. 303 is the best by far for UV and does not leave that Armor All slippery feel. I have never patched it. Brass oar locks, Carlisle Oars, Oar Rites, Anchor system inc. anchor, bow line, Ice Cooler rowing seat for storage, Pump included.


Break down frame, solid floor in front and rear casting areas to make the casting much easier, stable, and less tiring plus comfortable seats. Frame is older but the most comfortable to fish from for hours and also more range to cast from. Casting platforms are higher than most. I have been in many rafts and boats over the years and this is the most comfortable for fishing.


Very nice tilt trailer, all lights work, 1 7/8 ball, carpeted, roller?, hand winch to load raft, bearing buddies, spare tire and licensed thru December 2016.

I don't need the money so I will not give it away but would rather have it be used for the right person to take care of it. Thanks for looking, however I will not respond to any low ball offers.
$2250 or OBO


1 - 3 of 3 Posts
Not open for further replies.