Washington Fly Fishing Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
355 Posts
Discussion Starter · #1 ·
I have used some uv resin as a coat on some chironomids. I have noticed a few cloudy areas in the chironomid finish. Anyone else have this problem? What should I be doing so I do not get this cloudiness?
Thanks
Mike
 

· Registered
Joined
·
2 Posts
I've had the same problem but primarily on nymphs that I just apply the resin to the wing case. No problem on flies that I completely encapsulate the entire fly with the resin and none where I do a finish coat with "Hard as Nails".
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top