Washington Fly Fishing Forum banner
1 - 2 of 2 Posts

·
Driven by irrational exuberance.
Joined
·
1,584 Posts
Discussion Starter · #1 ·
I've been using Zap-a-Gap for connecting eyes and foam pieces to hooks with thread wraps. But transporting or storing the stuff safely has been a problem. I found out last winter that if I carefully set a bottle upright and drive up to the pass, sometimes the pressure change will pop the top and the stuff is capable of eating through a zip lock and making a big mess. If I put it in some kind of can, then the can lid gets glued on if there's a leak.

I discovered that there is a Super glue dissolver, available at Fred Meyer, that helps clean up the hardened glue. But I'm looking for new ideas from this auspicious body.
 

·
Registered
Joined
·
729 Posts
i cut the tip off the bottle so it is like a bottle of visine, snap the little cap on then put the lid with the applicator still on there cause its useless and throw it in a zip lock bag. never have had a problem with it leaking, make sure excess glue is away from the hole so the cap fits nice and snug. later Ben
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top